Waterproof Slim-Fit Surface Mount Cockpit LED Puck Light

Product Description

These are great little surface mounted white plastic and waterproof LED lights to be used in the cockpit, under gunwhales, or overhead in T-tops, arches, etc.

They are super bright at 2.2W and 140 Lumens, and are easily installed using the screws provided.  The trim ring pops off, and the 100% sealed inner module is screwed to any flat horizontal or vertical surface.  The bezel then snaps back on, covering the mounting hardware.   The internal module is hermetically sealed, so no water or moisture can ever get in.  The module includes a 6" length of 22AWG color coded wire, for connecting to your boat or RV's 12VDC supply.  

Can be dimmed with our PWM LED dimmers.

The lamp uses six Samsung LED emitters that produce a bright yet pleasing warm white light.  This lamp uses a special difussion technology that eliminates the "dazzle" or spots normally seen with LED lights. 

If you are looking for nice, bright, waterproof LED lights that look great and can be easily surface-mounted almost anywhere, then these cockpit lights are for you.

Satisfaction 100% guaranteed.

• Mounting: Surface Mount using 2 screws (included)
• Dimensions: 2.8" Dia. x  5/8"
• Waterproof rating: IP67 Waterproof
• Material: Polycarbonate plastic housing
• Wattage: 2.2W
• Voltage: 11-15VDC
• Output: 140 Lumens
• Beam Angle: 120°
• Color Temperature: Warm White 2900-3000K

Notes on mounting:  These lamps are meant to be surface mounted and are 100% waterproof (IP67).  It is intended that they be mounted with the screws provided, and the wire run behind the fixture, normally through a small hole drilled in the mounting surface.  The lamps should be mounted professionally on bedding compound or sealant like 3M 4200 or Lifecaulk polysulfide.  This will prevent water for entering the drilled holes into compartments, etc.