- Voltage: 10-30VDC
- Wattage: 0.6W (Red); 2.5W (Warm White)
- Amperage (12V): 0.05 Amp (Red); 0.21 Amp (Warm White)
- Luminous Flux: 145 Lumens
- Beam Angle: 120°
- Dimensions: 57mm x 57mm x 8.5mm thick
- Replaces: Bayonet Base 1141, 1142, 1156, etc.
G4 Halogen Bi-Pin Base
Wedge Base 194, 912, 168, 921, T10, etc.
- Warranty: 2 years
This drop-in bayonet LED replacement features two modes from the same bulb! It can function as either a red bulb, for preserving night vision, or with a quick flick of your existing switch, it can morph into a high-output super-bright Warm White bulb.
No need for changing out fixtures or wiring- imagine being able to convert any 5"+ dome light in your boat to a red/white without two bulbs and 3-way switches. This is all accomplished using a digital latching technique within the bulb's microprocessor electronics. When initially switched on, its output comes from the three center red LEDs. This provides a low intensity red output that is more than enough to see down below at night. The bulb senses each toggle of the switch and latches into the Warm White mode if the switch is toggled off-on within 3 seconds. Reverting to red mode is done by simply waiting more than 3 seconds after turning off the light.
Our unique 15-LED matrix is designed to fit perfectly in the standard 5" and 6" dome lights like those made by ABI, AAA, West Marine, and Cabin, among others. We offer it in all the standard bulb base styles, including Bayonet Single-Contact (BA15S), Bayonet Double-Contact (BA15D), T10 Wedge (W2.1x9.5d), Festoon (SV8.5), and Bi-Pin (G4). Custom bases or pigtails by request.The bulb features 3 Red and 12 Warm White triple-emitter SMD LEDs, along with a peel-and-stick foam mount backing that makes installation easy, even on concave or irregular surfaces. For curved surfaces, simply taper the edges of the adhesive foam backing to meet the shape of the housing. Our emitter board also has a special notch cut-out for the socket, so the bulb fits perfectly centered.
Works the same as our Red/White "Switchable" G4 Bulb.
17 Reviews Hide Reviews Show Reviews
A great solution!
Had this for over a year. Installation was straight forward and it provides ample light with easy switching between red and white.
Just a bit too large to fit (glued) in my 1996 Grady white dome light. I was able to set it on the plastic dome cover and screw the cover in place. Works fine.
I like the light very bright for white and just enough red to see. I noticed that the light adhesive attachment has failed and one side of the light is resting on the inside ceiling fixture cover. I will apply a dab of glue to reinforce the adhesion.