Marinebeam's USCG Certified NavLight™ LED side light
Marinebeam LED Sidelights are typically used in pairs, but they are sold separately.
These 112.5° LED sidelights replace traditional red and green sideboard lights which are mounted on the port and starboard side of the vessel, on a vertical surface, which is in-plane with the center-line of the boat.
Our lamps feature colored lenses, so they match the aesthetic appeal of traditional lamps, and are more attractive than some of the more industrial-looking and more expensive options on the market. Because colored lenses have high transmittance coefficients for like-colored LED wavelengths, our lamps are much more powerful --while using 90% less energy-- than traditional incandescents. They are also maintenance-free, have a super long life, and are waterproof.
Visibility exceeds 2 NM, and the lamps meets USCG and ABYC A-16 standards, and are US Coast Guard Certified (USCG) for use on vessels up to 65 feet (20M).
Like all Marinebeam products, our LED navigation lights have our integrated internal Constant-Current chipset, so they can operate at voltages from 9-33VDC. This means they are great for both 12VDC and 24VDC applications. This also provides protection from over-voltage conditions, transient surges, and provides for consistent output and safety even at very low battery levels.
Our navigation lamps do not emit RF harmful interference, and are EMC certified to EN55022, EN61547, and EN60945, so they will not interfere with radios, sensitive electronics, or GPS signals.
Includes two (2) stainless steel mounting screws, and 8' of duplex 18AWG tinned wiring to allow power connection to be below decks if desirable.
- Voltage: 9-33VDC
- Power: 2 Watts
- Visibility: 2NM
- Sector Angle: 112.5°
- Housing Color: Black or White
- Output Color: Red(Port) or Green(Starboard)
- Ingress Protection: IP67 (fully sealed)
- Approvals: USCG 33CFR183.810, ABYC A-16, EN55022, EN61547 & EN60945
- Dimensions: 3-7/16" Tall x 3-1/16" Wide x 2" Deep
Click here for Dimensioned Drawing
Marinebeam NavLights have a unique snap-in housing, which makes mounting super easy.
Mounts using (2) vertically aligned screws 50mm apart - adopted by the new Perko NaviLED PRO for direct replacement.
4 Reviews Hide Reviews Show Reviews
LED Navigation lights
Well made, but I’m disappointed in the cheap mounting bracket. Many of us our replacing old navigation lights that are mounted on stainless steel plates on the bow. The cheap bracket that comes with these lights only has two screw holes and the wire pokes out the back of the bracket 1”, so you aren’t able to snake it through an existing wire hole unless the new light exactly lines up with your old one, which is unlikely. I just spent two hours drilling three holes in my stainless plate. A better designed mounting plate allowing multiple possible attachment points would make this a great navigation light
Perfect in every way. Be careful aligning the cabling hole before you drill it...
This units are completely molded and tight. Installed it 4 years ago on our live-aboard ship. Maybe the one or other would wish longer cables to reach a junction box inside the hull on a dry location. I would recommend to deliver the units with min. 5m length of cables.
Good product, suggest marking top of the light unit as well as the bracket to clarify for install
Mark top of light unit as well as the bracket to clarify for install, make the wiring exit the same for left and right, ie: towards the stern.